Table Tents for United Way – Annual Day of Caring Kickoff – Planned for Sept 5, 2019

Parts List:
A Wood Knob – 1 ¼” diameter
B Wheel – 1 ¼” Diameter
C Post – ½” dowel x 11 ½” long
D Cross Bar – ¼” dowel x 9” long
E Base – 3” x 3” x 1 ½” thick

Quantity: 200 each part

Process:
1. Drill ½” hole in center of Wheel B. Use wheel holding jig.

2. Cut Post C to length; then drill hole for cross bar D. Center of hole should be 1 ½” from top of post. Use “G” DRILL BIT – which is slightly larger than ¼”. Use V groove jig to hold post for drilling.

Remove blue tape and manufacturer’s label from post.

3. Cut Base E to size, then drill a ½” hole – ¾” deep in the center of each base, using a ½” Forstner bit. Sand as needed, round over top and vertical edges with 3/16” round over bit.

insert pics of making the bases here

4. Cut Cross Bar D to length. Then round over the ends of the crossbar – setup a jig, using a strip of wood less than ¼” thick, on router table, use 1/8” round over bit. Rotate dowel at bit with large eraser stick.

5. Round over the bottom end of Post C – setup a jig, using a strip of wood less than ½” thick, on router table, use 3/16” round over bit. Rotate dowel at bit with large eraser stick.

6. Glue Wood Knob A to Wheel B (This becomes sub-assembly A-B.)

7. Glue Post C to sub-assembly A-B (this becomes Post Assembly A-B-C)

8. Finish as needed with clear lacquer, or other appropriate finish.

9. Deliver in three pieces: Post Assembly (A-B-C), Crossbar (D), and Base (E)

For more information about the Woodworkers, click here: RCWA

Rapid City Woodworkers Association